Boas, tenho duas dúvidas:
1ª Na calibração o Denon manda colocar o Gain a meio, mas qual a posição que coloco o Low Pass (Hz)? 120Hz ou LFE? eu coloquei em LFE e no fim da calibração está nos 120Hz no sub e por defeito no Denon. No Level ficou em - 12.0db, sinto que falta qq coisa mais...
O Phase penso ser na posição 0º
“LOWPASS” Control - The crossover point chosen determines
where low bass frequencies are “handed off” from the speakers to
the subwoofer. If setting the crossover point in the receiver, turn the
Lowpass Filter knob on the subwoofer to the farthest point right
(160Hz). Set the crossover point based on the size of the main left/
right speakers you are using in the system. As a general rule, for
larger, floorstanding speakers, set the crossover point between
50Hz-90Hz. If using small bookshelf or “satellite” speakers for the
mains, set the crossover point between 90Hz-150Hz. The smaller
the speaker, the higher the setting until the bass frequencies blend
well between the speakers and your subwoofer once your system is
completely hooked up. If your receiver does not have a crossover
point setting, set the Lowpass Filter on the subwoofer instead within
the same recommended settings (see receiver manual for additional
speaker setup info)."
2ª dúvida, tenho as colunas laterais com o tweter apontado para o "listening position" mas já vi que muitos de voçes tem na posição frontal, qual a melhor?
Cumps.